SECTION 2 - PROGRAMMING THE VoFX
The VoFX is designed to be both easy to program and flexible. The structure of
an VoFX Program is logical, and it doesn't require a lot of time to master.
To Select Programs in the VoFX:
1) After you power up, use the Data wheel to scroll through the Programs. As
you scroll, the effect group and footswitch LEDs turn on and off. These LEDs
indicate which effects are used in each Program, and which Program in the
Bank is selected.
There are 13 effect groupings printed on the front panel of the VoFX. 9 are
digital effect groups (delay, reverb, etc.) , and 4 cover the preamp section
(compression, Mic Driver, EQ). Each group has its own LED that indicates
the status of each group.
If the Effect LED is lit continuously, an effect in the indicated group is active. If
the LED is not lit, no effects in the group are active. If the LED is flashing, edit
mode is active, and effects in the group can be selected using the Data wheel.
Directly below each
vertical
group are the <Effect Selector buttons>. These but-
tons allow you to select and/or bypass effects in the VoFX. The following things
happen when you use the Effect Selector buttons:
• When you select a bypassed effect, its group LED begins flashing and the dis
play shows two dashes, indicating that the effect is selected but bypassed.
(Pressing the Select button again activates the effect.)
• When you select an active effect, its group LED begins flashing and the dis
play shows the number of the currently selected effect. (Pressing the button
again bypasses the effect.)
When lit, the User LED below the display indicates that the current Program is a
User Program. When the LED is not lit, the current Program is a permanent
Factory Program.
Using The Footswitches
The VoFX's pedalboard consists of four footswitches: the far right footswitch is
the Bank selector, and the remaining three are Program selectors.
A Bank is a group of three Programs. There are 10 User Banks in the VoFX,
each with 3 Programs for a total of 30 User Programs. There are also 30 Factory
Programs that can be selected using the Data wheel only. User Programs in any
of the Banks can be recalled in one of two ways:
• by pressing the Bank select footswitch, followed by footswitch 1, 2, or 3.
Signal Processing
6
Signal Processing
Signal Processing
VoFX manual 7/25/00 11:04 AM Page 6
