background image

IMPORTANT!

FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:

WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so
that objects do not fall on and liquids are not spilled into the enclosure through openings.
POWER SOURCES: The appliance should be connected to a power supply only of the type described
in the operating instructions or as marked on the appliance.
GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization
means of an appliance is not defeated.
POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them, paying particular attention to cords at
plugs, convenience receptacles, and the point where they exit from the appliance.
SERVICING: The user should not attempt to service the appliance beyond that described in the
operating instructions. All other servicing should be referred to qualified service personnel.
FUSING: If your unit  is equipped with a fuse receptacle, replace with only same type fuse. Refer to
replacement text on the unit for correct fuse type.

Warranty

1.  The warranty registration card must be mailed within ten days after purchase date to validate this warranty.
2.  DOD warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and

service. 

3.  DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product

is returned to DOD 

WITH RETURN AUTHORIZATION, 

where all parts and labor will be covered up to a period of two (2) years. A Return

Authorization number may be obtained from DOD by telephone. The company shall not be liable for any consequential damage as a result
of the product’s use in any circuit or assembly.

4.  Proof-of-purchase is considered to be the burden of the consumer.
5.  DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any

obligation to install the same on products previously manufactured.

6.  The foregoing is in lieu of all other warranties, expressed or implied, and DOD neither assumes nor authorizes any person to assume for it

any obligation or liability in connection with the sale of this product. In no event shall DOD or its dealers be liable for special or conse-
quential damages or from any delay in the performance of this warranty due to causes beyond their control.

DOD® and VOFX™ are registered trademarks of DOD Electronics Corporation.

The information contained in this manual is subject to change at any time without notification. Some information contained in this manual
may also be inaccurate due to undocumented changes in the product or operating system since this version of the manual was completed. The
information contained in this version of the owner's manual supersedes all previous versions.

Safety Precautions

Please, by all means, do not attempt to service the unit yourself.  Refer
all servicing to qualified personnel. Opening the chassis for any reason 
will void the manufacturer's warranty. Do not get the unit wet. If liquid is 
spilled on the unit, shut it off immediately and take it to a dealer for

service. Disconnect the equipment during storms to prevent damage.

VoFX manual  7/25/00  11:04 AM  Page 2

Содержание VoFX

















Отзывы: