C L 1 U S E R S G U I D E
D O D T E C H N O L O G I E S , I N C
Rev 10.07
Page 42
Advanced Optics Cleaning
1)
Exit analysis mode and open the gate and remove the tape.
2)
Power down the CL1
3)
Remove the optics back plate cover as shown in Figures 3 & 4
Figure 2
Figure 3
4)
Remove the Optics Back Plate by removing the two Phillips head screws.
5)
Use a canned air supply to blow into channel two of the optics. Channel 2 is 2
nd
closest opening to the CL1 as shown in Figure 4. Use the canned air tube to direct
flow to both the top and bottom of the optics block.
Figure 4
NOTE: There are two versions of the Optics Back Plate. Rev 2 is displayed in Figure 4.
This version of the Back Plate has two holes that align with the posts.
Rev1 Optics Back Plate’s does not have these alignment holes.
6)
Re-Install the Optics Back Plate:
a.
If you have a Rev 2 Optics Back Plate slide the Optics Back Plate onto the
posts and re-install the Phillips head screws.
Optics Back Plate
Cover
Optics Back Plate