7
8
PAIRING THE COLLAR WITH REMOTE
Channel 1 and/or 2 are used when you want to MANUALLY trigger a
response when your dog barks or does a bad behavior that you want
to correct.
1. Make sure the toggle switch on Channel 1 Position.
3. Within 10 seconds, press and hold
button on the remote to pair the collar with
the remote. you will hear 2nd beep from the
collar, this confirms the pairing is complete.
4. Press the button to verify that the
Remote Training Mode is working.
Use the Intensity Dial on the remote to set the intensity level from
1-100 for Channel 1 or 2. Currently Intensity is 40 in use. the BEEP
mode is non-adjustable level.
If you want to pair another collar to the same remote, change the
toggle switch to Channel 2 and follow the same instructions.
Hold the button for 3 seconds
Press and hold one of mode buttons
HOW TO USE THE ANTI BARK MODE
Channel A is used when you want the collar to AUTOMATICALLY
trigger a response when your dog barks.
Change the toggle switch on the remote to Channel A position. It is
Anti Bark Mode now and will default to one of Anti Bark Mode, but you
can change the modes any time.
NOTE:
We was paired the collar to Channel 1 before, we have back
to the Channel 1. it is back to MANUALLY remote training mode.
NOTE:
We has been paired the collar with remote. So you can easy
right out of the box. Usually, one collar was paired to the Channel 1,
another one paired to the Channel 2.
2. Hold the button on the collar down for 3 seconds. You will hear 1st
beep from the collar and the LED light will flash green to confirm it
is in pairing status.
HOW TO PAIRING THE COLLAR WITH REMOTE
Run to the
Anti Bark Mode
Back to the Remote
Training Mode
NOTE:
Put the test light over the Contact Points of the collar and then
press the SHOCK button to verify SHOCK mode is working.
Содержание DB400
Страница 1: ...400...
