DoAll 500SNC, Инструкция по эксплуатации

Страница: 32 / 35

28
SAW HEAD WON'T LOWER
1. Hydraulics must be on and must in the "MANUAL
MODE" setting.
2. Check for faulty Solenoid 2 .
3. The feed rate is too low.
4. Check for saw head obstructions.
SAW HEAD LOWERS ERRATICALLY
1. Check for mechanical obstruction or binding.
2. Check for worn or damaged head feed cylinder or
head feed valve.
3. Check for air in the head feed cylinder.
SAW HEAD DROPS SLOWLY WHEN MACHINE
IS SHUT OFF
1. Check for a worn head feed cylinder.
2. Check for hydraulic system leaks.
INCOMPLETE CUT
1. Clear away build-up of chips or other debris on the
vise bed (check also for build-up below the saw
guides).
2. Adjust the head down proximity switch (4 PRS) .
3. Check the counterbalance spring adjustment.
VISES WON'T CLAMP
1. Hydraulics must be on and the CYCLE MODE must
in the "MANUAL" setting.
2. Saw head not raised high enough.
3. Check for faulty Solenoid 8 and 9 for index vise,
Solenoid 6 and 7 for front vise.
3. Check for a worn vise clamp cylinder.
4. Check for vise obstructions.
5. Check the optional Variable Vise Pressure
settings.
TROUBLE SHOOTING (Continued....) INDEX LENGTH PROBLEMS
1. Go to the HELP Screen and press "INDEX LENGTH
PROBLEMS" and follow the prompts if any.
INDEXER WON'T MOVE
1. Hydraulics must be on and must in the "MANUAL
MODE" setting.
2. The out of stock proximity switch ( 2 PRS or 1 PCS -
Nesting option) has been activated.
3. One of the vises must be unclamped before the
indexer will operate.
4. Check for a worn indexer feed cylinder.
4. Check for index vise obstructions.
5. Check for faulty Solenoid 3 and 4 .
OUT OF STOCK PROBLEMS
1. Go to the HELP Screen and press "OUT OF STOCK
PROBLEMS" and follow the prompts if any.