DoAll 500SNC, Инструкция по эксплуатации

Страница: 15 / 35

11
View Screen
1. When power is first turned on, the following screen
appears.
View Screen.
2. This screen shows a collection of keys to operate
the machine manually and to enter certain data.
For the saw head and vise functions to operate,
the hydraulics MUST be on and the operation
in the MANUAL MODE.
3.
Saw Head Up.
This key raises the saw head up
until the "SAW HEAD HOLD" key is pressed.
• When in "AUTO MODE", pressing the "SAW HEAD
UP" key will raises the saw head, stop the saw band
and will switch the saw to "MANUAL MODE".
4.
Saw Head Hold.
This key stops all saw head
movement.
5.
Saw Head Down.
Press and hold this key to lower
the saw head.
6.
Index Vise Clamp.
Press this key will close the
index vise.
7.
Index Vise Open.
Press and hold this key will open
the index vise. Release the key to stop vise jaw
movement.
8.
Hydraulic Start.
Pressing this key starts the
hydraulic pump motor.
9.
Hydraulic Stop.
This key stops the hydraulic pump
motor.
Keypad.
2. Features of the keypad include:
3 Display Window. Located in the upper left corner,
the display shows the values entered.
4. Backspace. Pressing this key will delete the last
entry keyed in.
5. Clear. This will delete the entry in the display.
6. Data Limits. Below the display window will show a
"LOW" and a "HIGH" value. These values are the
low and high limits of the data that can be entered
for that function.
7. 0 - 9, Decimal Point, + / -. These keys are used to
enter values for that function. Enter them in order
including the decimal point.
If you make an error in entering data, just press
the Backspace or Clear key, correct or reenter
you value and then press the OK key.
8. OK. Pressing this key will enter the data into memory
and then will return to the previous screen.
9. Cancel. Pressing this key will bring you back to the
previous screen. No data will be entered.
10. A thru F. These keys are not functional and are
not used.
"Format" is NOT to be changed for any reason.
The "Dec" button should ALWAYS be selected.
Any other selection will cause errors and
undesireable results in setpoint values.
OPERATOR WORKSTATION (Continued....)