14
Jobs Screen
1. The
Jobs
Screen shows a collection of keys to enter
data for running a series of cuts automatically. The
top row shows a group of keys help accomplish this
task.
•
On the
SETUP
Screen, the "JOB MODE RUN LIST"
must active for this screen to be accessed.
Jobs Screen.
2.
Clear All Jobs.
Pressing this key completely clears
all data on the screen.
3.
Reset All Dones.
When pressed, all entries in the
dones column are changed to 0 (zero).
4.
To enter data in the run list:
(a)
Press the "#1
LENGTH" key and the keypad will appear;
(b)
Enter
the desired cut length and then press
OK
;
(c)
Press
the "#1 QTY" key and the keypad will appear;
(d)
Enter the desired number of cuts and then press
OK
.
5.
Press the "#2 LENGTH" and proceed as before until
the run list is finished.
Check and make any corrections/additions to
the run list before exiting the JOBS Screen.
Once exited, the jobs programmed in the list
can not be changed while running in "AUTO
MODE".
6.
To skip a job or jobs in the list, set the quantities to
0 (zero) on the jobs to be skipped.
7.
Operator notes about entering jobs into the list:
(a)
The minimum automatic index length is.250 inch
(9.5 mm);
(b)
The maximum index length that can
be entered is 9999.99 inches or millimeters;
(c)
The
maximum quantity that can be entered is 999.
Help Screen
1.
This screen shows the operator a series of keys to
help solve common problems that may occur during
operation.
Help Screen.
2.
Press the key that matches the problem and then
follow the prompts listed.
PLC Input/Output Screens
1.
On the
HELP
Screen, it shows "PLC INPUTS" and
"PLC OUTPUTS". These screens show different
PLC input and output modules and their status.
These modules are for diagnostics and service only
and needs NO interaction from the operator.
SAW BAND PREPARATION
Recommended Saw Band
1.
The machine is shipped with a saw band installed.
The saw band recommended for use with this
machine is 197 inches (5003.8 mm) long, 1-1/4 inch
(31.7 mm) wide, and has a 0.042-inch (1.67 mm)
gage thickness.
Blade Guards
1.
The following blade guards are positioned to provide
operator safety while the machine is running:
(a)
A top guard located above and between the
bandwheel doors;
(b)
A guard mounted between
the lower left saw guide arm and the left bandwheel
door;
(c)
A guard assembly between the lower
right saw guide arm and the right bandwheel door.
Blade guards (b) and (c) may be removed to help
facilitate saw band changing procedures.
DO NOT defeat the purpose of any guard
or safety devise. They are there for YOUR
PROTECTION!
OPERATOR WORKSTATION (Continued....)
Содержание 500SNC
