DoAll 500SNC, Инструкция по эксплуатации

Страница: 28 / 35

24
BANDWHEELS (Continued....)
2. Occasionally check each bandwheel's back-up
flange and wheel tread for wear. Saw bands will not
track properly if the wheel tread's taper is worn.
COUNTERBALANCE SPRING
1. After a period of time, the saw head may not cut
through the stock or cuts too far into the vise bed
wear plates. To adjust, follow these procedures:
• There is no need to remove the counterbalance
spring from the machine.
(a)
Loosen the threaded
collar from the lower hex nut;
(b)
Adjust the lower
hex nut up or down until the saw band teeth are
approximately 0.06 inch (1.52 mm) below the work
surface;
(c)
Turn the threaded collar down tightly
on top of the hex nut and secure it.
Be sure the saw head falls only enough to
cut completely through the work. TOO MUCH
head fall could result in cutting the vise bed
wear plates too deeply or completely off. TOO
LITTLE head fall will result in an incomplete
cut through the workpiece.
Counterbalance Spring.
ELECTRIC MOTORS
1. Follow the manufacturer's maintenance instructions
for each electric motor. These instructions are
located in the pocket inside the main electrical
enclosure.
MIST LUBRICATOR
1. See the instructions sent with the unit for information
on maintenance and adjustments. They are located
in the pocket inside the main electrical enclosure.