DLoG MTC 6, Руководство пользователя

Страница: 16 / 89

Basic safety guidelines
6 User’s Manual V1.00 DLoG MTC 6
2.4. Initial operation of the device
Area of application: not for use in life-support systems or critical safety systems
The device is not designed for use in life-support systems or critical safety systems
where system malfunction can lead to the direct or indirect endangerment of human
life. The operator shall take full responsibility for using the device in these situations.
The device cannot be used in combination with safety functions for machines and
equipment which have to conform to the requirements of EN 954-1.
Risk of injury during transit or installation
The unit could fall during transit or installation and cause injury. Always ensure that
there are two persons available when installing or removing the device.
Choice of location – observe the protection class
The ambient conditions at the point of installation must comply with the device’s
protection class.
Supply of fresh air – avoid overheating the unit
The DLoG MTC 6 is based on a passive cooling concept. As a result, the waste heat
which is produced inside the device is emitted over the surface of the housing. For this
system to function properly, sufficient fresh air circulation is required. Never install the
system in a closed environment where the cooling air is unable to dissipate
accumulated heat to the outside.
If the DLoG MTC 6 is not able to draw in fresh cooling air, this may cause overheating
and severe damage to the unit.
The maximum allowed ambient temperature for the system needs to be taken into
account for the concrete application area.
Install an easily accessible disconnecting device
The device is not supplied with a disconnector (switch) that can be accessed
externally. The power supply connector is therefore used as a disconnector. Therefore
it needs to be easily accessible.
If it is necessary to establish a fixed connection, an easily accessible disconnecting
device (e.g. a switch such as a circuit breaker) should be installed close to the device.
Ensure that the power cable is laid so that it is mechanically protected.