djm direct DJMBAS80, Руководство по эксплуатации

Страница: 8 / 23

7
10. Assembly
This band saw was partially assembled at the
factory. To assemble your machine follow the
below instructions.
Work Table
1. Remove the two screws, two knurled nuts and
U shape block from the work table.
2. Guide work table over the blade and place it on
the table trunnion. Positon the table insert on the
work table properly.
3. Attach the work table with three each screws
M6×16 to the table trunnion.
4. Fasten the work table with three nuts M6 and
three fla t washers.
5. Attach two screws and two knurled nuts with
U shape block that were removed in step one and
fasten.
Push Stick
1. Fix the screw and nuts on the machine, leaving
room for push stick.
2. Hang the push stick on the screw
.
Rip Fence
Clamp the rip fence. It can be used on both sides
of blade.
1
2
Work Table
Table Insert
NOTE: Before fastening the work table,
make sure table be aligned in two
planes. Laterally, in order for the blade
to run dead centre through the table
insert.At right angles to the blade.
3
TOP
VIEW
BOTTOM
VIEW
M6
×
16
(
×
3)
Bench Angle Gauge
M6 Nut
(
×
3)
M6 × 16 × 3
A
M6
×
35
(
×
1)
M6 Nut
(
×
1)
M6 × 35
× 1
B