djm direct DJMBAS80, Руководство по эксплуатации

Страница: 15 / 23

14
Thrust bearing adjustment
1. Loosen the two screws and remove the under
blocks.
2. Loosen the three screws and Remove the
working table from the table trunnion .
3. Loosen the two knobs and remove the bench
angle gauge.
4. Open the lower housing door.
5. Raise upper blade guide fully.
6. If necessary, align and tighten the band saw
blade.
7. Loosen the thrust bearing's locking screw.
8. Adjust thrust bearing position (distance thrust
bearing - band saw blade = 0.5 mm
- if the band saw blade is turned by hand, it shall
not touch the thrust bearing.
4. Tighten the thrust bearing locking screw.
Guide pin adjustment
1. Loosen screws.
2. Press guide pins together, keep 0.5 mm
distance between guide pin and the saw blade.
3. Tighten screws again
Lower Blade Guide Alignment
The lower blade guide consists of:
● a thrust bearing (supports the band saw blade
from the rear),
● two guide pins (providing lateral support).
NOTE: Periodically check thrust
bearings and guide pins for wear, if
necessary replace both guide pins
at the same time.