djm direct DJMBAS80, Руководство по эксплуатации

Страница: 12 / 23

11
ON/OFF Switch for Lamp
Press "I" to turn on the lamp.
Press "O" to turn off the lamp
This light switch can only work when the ON/OFF
switch for the product is turned on.
Sawing
1. If necessary, adjust the table tilt.
2. Select rip fence and table tilt for the type of
cutting operation to be carried out.
3. Set upper blade guide 3 mm above the
workpiece.
4. Place workpiece on the working table.
5. Plug in.
6. Start saw.
7. Cut workpiece in a single pass.
8. Switch off if no further cutting is to be done
immediately afterwards.
13. Maintenance
General Maintenance Measures
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it with
compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device. The ingress of water into an electric tool
increases the risk of an electric shock.
In order to extend the service life of the tool, oil the
rotary parts once monthly. Do not oil the motor.
Saw Blade Change
Use only suitable band saw blades.
1. Loosen the 2 knurled screws and remove the U
shape blocker.
2. Open both housing doors.
3. Loosen setting knob until the band saw blade
has slackened.
4. To remove the band saw blade, guide it through
the slot in the working table.
5. Fit fresh band saw blade. Ensure correct
position: the teeth must point towards the front
of the saw (where the doors are).
6. Center band saw blade on the rubber tyres of
the band saw wheels.
7. Tighten setting knob until blade does no longer
slip off the band saw wheels.
8. Close both housing doors.
9. Tension band saw blade;
Align band saw blade and align blade guides;
let saw test run for at least one minute;
Stop saw, unplug and recheck settings.
Always make a trial cut in a piece
of scrap to verify settings; correct
if necessary before cutting the
workpiece.
Machine has suction connector,
user can connect the machine to a
proper suction unit when working.
Danger by jamming workpiece!
When using the rip fence with a
tilted saw table, the rip fence must
be installed on the lower side of the
working table.
Warning! Prior to any adjustment,
maintenance or service work
disconnect the mains power plug!
Danger! Risk of injury, even with the
band saw blade at standstill. Wear
gloves when changing blades.