djm direct DJMBAS80, Руководство по эксплуатации

Страница: 7 / 23

6
9. Machine Use and Care
-Do not use low-output electric tools for heavy work.
Do not use the electric tool for purposes for which it
is not intended. For example, do not use Band Saw for
the cutting of branches or logs. Do not use the electric
tool to cut firewood.
-When the saw blade is blocked due to abnormal
feed force during cutting, turn the machine off and
disconnect it from power supply. Remove the work
piece and ensure that the saw blade runs free. Turn
the machine on and start new cutting operation with
reduced feed force.
-Do not remove any cutting residues or other parts of
workpieces from the cutting zone while the machine is
running and the saw unit is not at rest.
Never remove loose splinters, chips or jammed pieces
of wood while the saw blade is running.Switch off the
machine to troubleshoot or remove jammed pieces of
wood.
-
Do not begin cleaning the blade until it has
come to a complete standstill.
Wear safety gloves
whenever you carry out any maintenance work on the
blade!
-When cutting round or irregularly shaped wood, use
a device to stop the workpiece from twisting.
Ensure
that the choice of blade and the selected speed
are suitable for the material to be cut.
-When cutting boards in upright position, use a device
to prevent kick-back.
-A dust extraction system designed for an air velocity
of 20 m/s should be connected in order to comply
with woodworking dust emission values and to ensure
reliable operation.
-If you use a cable reel, the complete cable has to
be pulled off the reel.
-Persons working on the machine should not be
distracted.
-Note the direction of rotation of the motor and
blade.
-Never cut workpieces which are too small to hold
securely in your hand.For straight cuts of small
workpieces against the longitudinal limit stop the
push stick has to be used.
-Never operate the machine if either the door
protecting the blade or the detachable safety
device are open.
-The band saw blade guard should be in its lowest
position close to the bench during transport.
-For miter cuts when the table is tilted, the
parallel stop must be positioned on the lower part
of the table.
7. Introduction
Your new band saw will more than satisfy your
expectations. It has been manufactured under
stringent quality standards to meet superior
performance criteria. You will find it easy and safe to
operate, and with proper care, it will give you many
years of dependable service.
8. Application Conditions
This band saw is designed for operating under
ambient temperatures b5°C and 40°C
and for installation at altitudes no more than
1000m above M.S.L. The surrounding humidity
should less than 50% at 40°C. It can be stored
or transported under ambient temperatures
between -25°C and 55°C.
* S2, Short-time duty. After continuous operation
of 15 minutes the machine stops until the device
temperature deviates by less than 2 K (2°C) from
the room temperature.
* The noise was measured according to EN 61029-2-
5:2011+A11.
Carefully read through this entire
operator’s manual before using your
new band saw. Take special care to
heed the cautions and warnings.
Sound pressure level
(LpA)
Sound power level
(LwA)
82.6 db(A)* k=3 db(A)
93.6 db(A)* k=3 db(A)