djm direct DJMBAS80, Руководство по эксплуатации

Страница: 11 / 23

Adjusting the Blade Guard
The blade guard protects against unintentional
contact with the saw blade and from chips flying
about. In order for the upper blade guard to
provide adequate protection against contact with
the band saw blade, it must always be set as close
as possible against the workpiece
(max. distance 3 mm).
1. Loosen the locking knob.
2. Rotate the setting knob to adjust the blade
guard in the right position, then fasten the locking
knob.
12. Operation
Mounting the saw in the stable and flat
supporting surface
1. Drill 4 holes in the supporting surface.
2. Put fixing bolts through the base plate and
secure with nuts.
ON/OFF Switch
The saw can be switched on by pressing the
green pushbutton.
The red pushbutton has to be pressed to switch
off the machine.
10
Start the saw only after the following
preparations are completed:
● The saw is fastened;
● The saw table is installed and
aligned;
● Safety devices have been checked.
Connect the saw to the mains supply
only after all of the above preparations
are completed! Otherwise there is a
risk of an unintentional starting of the
saw, which can cause severe personal
injury.