-4- Radio parameters
Menu : Radio
► Group: Diwel
Scan RF1
Channel1 : 02 (5200 MHz)
Channel2 : 08 (5320 MHz) ▼
•
Enter your name network on each product
Tx and Rx
! Note ! The network name has to be the same on each receivers and the transmitter.
Main menu → Down arrow button → Left arrow button
→ “Radio” menu selection → centre
button to enter → centre button to select “Name” sub-menu → right/left and up/down arrow to
change values → centre button to validate
•
scan available frequencies
Tx or Rx
Main menu → Left arrow button → Down arrow button
→ “Radio” menu selection → centre
button to enter → up or down arrow to select the SCAN sub-menu → centre button to begin scan
Ch : 06 (5280 MHz) : - 50 dB
1
Bar graph indicates used frequencies around your product:
–
You can check the power of each detected signal in the top of the screen
–
The number under each bar-graph indicates the number of transmitter using the selected
channel. A number in reverse colour means that a DIWEL product use this channel.
! Note !
When you start a frequencies SCAN from your transmitter, the radio head N°1 stops to
transmit in order to operate as a receiver. The only visible frequency on the screen is the radio head
n°2 that still transmitting a signal.
If your actually frequencies are not available, you have to choose new ones.
•
select two frequencies on the transmitter
Tx
Menu : Radio
Group : Diwel
Scan RF1
► Channel1 : 02 (5200 MHz)
Channel2 : 08 (5320 MHz) ▼
•
14/28
