PUTTING REALITYCASTERS INTO OPERATION
-1- Connect power-supply cable and the antennas
you have.
You have to connect the 2 antennas to each device in order to obtain an optimized transmission
quality :
–
either the little 3dB gain black omnidirectional antennas delivered with product, used to
cover short distances;
–
for over long distances broadcast
–
omnidirectional antennas at the transmitter
–
and directional antennas at the receiver
–
50 Ohms 6GHz N connectors cables.
-2- Video parameters :
•
Switch on the power supply
Tx and Rx
•
Select your video source of your transmitter
Tx
Menu : Video
Res In : D1920x1080P60
► Input : HDMI
Bit-rate : 08 Mbit/s
Mode : Rand ▼
Choose : HDMI or DVI, VGA, SDI (option)
For example :
Main menu → Left arrow button
→ Down arrow button→ “Video” menu selection thanks the
centre button to enter → right arrow button to manage parameter → up or down arrow to change
parameter. Choose “HDMI”→ centre button to validate
•
You can connect your video cable
Tx
! Note !
At each moment, you can go back to main menu thanks to upper or down left triangle
button (button 1 or 4 on the front plate description).
! Note !
You can check the format of the video your are transmitting (“Res In”). No data indicate
that format is not valid!
•
Video bit-rate selection
Tx
This value starts at 1 (very low encoding resolution) to 8 (high-resolution encoding). By default,
keep this value to 8. For the extreme conditions of use (very long distance, important obstacles),
you can decrease this value. It can improve the robustness of your radio signal and thus to obtain a
better quality of radio reception. The image can potentially be less fluid, slightly bitmap display.
11/28
