Divine DL-1040 DLX, Руководство пользователя

Страница: 15 / 40

15
ture button again before the display stops flashing. Each press of “Warm” or
“Cool” will adjust the set temperature. After three seconds, the display will
stop flashing and begin to display the current spa temperature.
Jets 1
Press “Jets 1” to turn pump 1 on or off. The device will turn off after 15 minutes.
Jets 2
Press the “Jets 2” to turn pump 2 on or off. The device will turn off after 15
minutes.
Jets 3
(7-button topside control panel)
Press the “Jets 3” to turn pump 3 on or off. The device will turn off after 15
minutes.
Light
Press “Light” to operate the spa light. Turns off after 4 hours.
Mode
Mode is changed by pressing “Warm” or “Cool,” then pressing “Mode.”
Standard Mode maintains set temperature. ‘
STD
’ (Std) will be displayed
momentarily when you switch into Standard Mode.
Economy Mode heats the spa to the set temperature only during filter cycles.
‘
Ecn
’ (Ecn) will display when water temp is not current, and will alternate with
water temp when the pump is running.
Sleep Mode
heats the spa to within 20°F/10°C of the set temperature only
during filter cycles. ‘
SLP
’ (SLP) will display when water temp is not current, and
will alternate with water temp when the pump is running.
Preset filter cycles
The first preset filter cycle begins 6 minutes after the spa is energized. The
second preset filter cycle begins 12 hours later. Filter duration is programmable
for 2, 4, 6, or 8 hours or for continuous filtration (indicated by ‘F ILC’). The
default filter time is 2 hours. To program, press “Warm” or “Cool” then “Jets 1.”
Press “Warm” or “Cool” to adjust. Press “Jets 1” to exit programming.
PLEASE NOTE:
For circulation systems, the circ pump and the ozone genera-
tor (if installed) run 24 hours. In hot environments, the circ pump may turn
off if the spa water is 3˚F higher than the set temperature, except during filter
cycles. At the beginning of each filter cycle all other equipment will run briefly
to purge the plumbing.