Divine DL-1040 DLX, Руководство пользователя

Страница: 14 / 40

14
Figure 1
6-Button topside control panel
Figure 2
7-Button topside control panel
TOPSIDE CONTROL – TURNING ON YOUR SPA
Topside control button reference display
Identify your topside 6-button control (figure 1) or 7-button control (figure 2).
After you identified your topside control system, and the spa is filled, turn your
power on and go to your controller spa operations.
Power on
It’s time to turn on the power. Set the breaker at the main service panel
to the on position. Now set the breaker at the service panel or spa dis-
connect outside the spa to the on position. Then proceed to Initial
Start-up referencing your specific control system.
Initial start-up
Your spa will enter Priming Mode (‘PR’) when it is energized. During
Priming Mode, press “Jets” button(s) repeatedly and be sure all pumps
are free of air. Priming Mode lasts less than 5 minutes. Press “Warm” or
“Cool” to exit sooner. After Priming Mode, the spa will run in Standard
Mode (see Mode section).
Temp control
(80°F-104°F/26°C-40°C)
The last measured water temperature is constantly displayed. The water tem-
perature displayed is current only when the pump has been running for at
least 2 minutes.
On panels with “Warm” and “Cool” buttons, to display the set temperature,
press “Warm” or “Cool” once. To change the set temperature, press a tempera-
IMPORTANT!
Do not turn
power on until
tub is full of
water and all
valves are open!