10
End of operation
Caution:
The machine must now be emptied and cleaned.
Switch off the machine (main switch) and discon
-
nect the battery disconnection socket before begin
-
ning with the following steps.
Removing and cleaning the suction nozzle
Notice:
Only cleaned and intact blades ensure optimal suc
-
tion results!
Empty and clean the recovery tank and fresh
water tank
Cleaning the recovery tank and fresh water tank
Caution:
Clogged suction filters may impair the suction per
-
formance.
• Press the Brush drive ON/OFF but
-
ton.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro
-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Lift the suction nozzle.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but
-
ton.
The display lights up; the suction en
-
gine stops.
• Switch off the machine.
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc
-
tion nozzle is released and can be re
-
moved from the squeegee holder.
• Clean the suction nozzle under running water using a
brush.
• Remove the drain water hose (red) from the holder.
• Put the drain hose into the drainage.
• Press the crushing point (1) of the drain hose.
• Pull the lid off the drain hose and
drain the recovery tank.
• Proceed in the same way for draining the fresh water tank.
For that purpose, remove the cleaning solution drain hose
(glue) from the holder.
• Open the tank cover until the support
engages in the tank wall.
• Rinse the recovery tank and the fresh water tank thorough
-
ly with clean water.
• Remove the dirt sieve (yellow), emp
-
ty it and thoroughly rinse it under run
-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hoses back into the holder.
1
1
