DITEC 0DT872, Инструкция по установке, обслуживанию и эксплуатации

Страница: 39 / 48

- 39 -
0DT872 01-12-2021
6.2 ADVANCED MENU
The advanced menu allows you to modify the position of the limit switches which have previously been set
and modify the set default parameters.
To access the Advanced Menu:
- STOP the door
- Set DIP 2 to ON
“ENCODER CALIB.”, the first item in the advanced menu, will appear on the display.
1 2 3 4 5 6 7 8
ON
ONCE PROGRAMMING HAS ENDED, SET DIP2 TO OFF
Remove cables from PIN 3, 4, 20 during programming
STEP 1
st
level options Scrolling Confirm 2
nd
level options Notes
1 Encoder Calibration Closed position The door will move to the desired
position in man present mode and
at low speed. All the positions
(closing, partial opening, opening)
must be set.
2 Photocell excluded
(step present only for
Reset doors)
Change value
(1 unit
≅
3mm)
By increasing the value, the
position of the photocell by-pass is
raised
3 Primary safety device
excluded
Change value
(1 unit ≅ 3mm)
By increasing the value, the
position of the primary safety by-
pass is raised
4 Automatic closing
(default SI with T= 5 s)
YES
NO
5 Automatic closing time Time variant Option available only if YES has
been selected for point 4).
Value ranging from 0 to 100 sec.
6 Command mode Impulsive Selecting 1-9: if 1-9 is closed, the
command mode will be impulsive,
if 1-9 is open the command mode
will be “dead man”
Man present
INPUT 1-9
7 Opening safety device YES If set to YES, the closed door that
receives an opening command
does not open if the photocell is
activated.
NO
8 Interlock NO INTERLOCK AIRLOCK: door 2 opens with ex-
ternal command only if door 1 is
closed.
INTERLOCK: door 2 opens auto-
matically when door 1 has closed
AIRLOCK
INTERLOCK
9 Pre-flashing when
opening
(default no)
YES Pre-flashing has a set time of
3 sec.
NO
10 Opening ramp advance CHANGE VALUE
(1 unit ≅ 3mm)
When the value increases, the
deceleration distance when
opening increases.
11 Opening speed
in (Hz)
CHANGE VALUE The setting of values that are
higher than the default ones
must be assessed according to
door dimensions and operating
conditions.
EN