22(33)
User manual in Original
Dok. ref: User manual 500A-BAS Rev. B
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: [email protected]
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
9.3.
Trouble Shooting
9.3.1.
Disposer Reduces Speed, stops or does not start
A humming sound might be heard from motor
1.
Press the red button (0).
2.
Use the main electrical safety switch to disconnect electrical supply. Lock the switch with a
padlock or a cable tie if you need to leave the disposer temporarily before step 9 is completed.
3.
Use protective gloves. Check if something is jammed in the disposer.
4.
Check if something is jammed in the disposer. If so, place the jam release wrench on the center
washer. See picture below.
5.
Release the grinder by rotating the wrench backwards and forwards until the shredder
rotates freely in both directions. If needed, extend the bar on the wrench and hit
the bar with a hammer.
6.
Remove the jam release wrench.
7.
Remove any non grindable objects; for example cutlery.
8.
Check fuses/breakers. Change/reset if needed.
9.
Use the main electrical safety switch to connect the electrical supply.
10.
Press the green button (1) to start and empty the disposer.
9.3.2.
The Disposer starts but there is no Flushing Water
1.
Is the stop valve in the water supply pipe open? If not, open stop valve.
2.
Is a clicking sound heard when activating the solenoid valve? If not, change the coil.
3.
Is the line strainer clogged? Turn off water supply, open strainer and clean. Close strainer carefully
without damageing the seal, and make sure it is thight when disposer is restarted.
9.3.3.
The Disposer does not start and makes no Sound
1.
Check the main electrical safety switch; make sure that it is in an ON-position.
2.
Check fuses/breakers. Change/reset if needed.
If the fault cannot be remedied please contact authorized service personnel or
Disperator AB / local representative. Always provide the disposer’s serial number
when contacting Disperator.
