15(33)
User manual in Original
Dok. ref: User manual 500A-BS Rev. C
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: [email protected]
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
Hoist alternative 2
Use a firm and well balanced jack with a support disk to hoist the disposer into position under the
mounting flange.
Hoist alternative 3
If no hoisting tools are available, place the disposer on a solid object of the proper height (for example
a wooden crate), and push it in under the mounting flance. To get the proper height of this object
measure the space between the floor and the mounting flance and then subtract the height of the
disposer and the rubber seal (3mm).
Mounting of models 520A, 530A, 550A and 575A, delivered with legs as standard
The weights of models 520A - 575A require legs for support. At installation site the speratly delivered
3 legs must be fixed to the 3 clamps in the disposer bottom.
Proceed as follows when mounting legs:
•
Measure the height (X mm) between the flange of the mounting assembly and the floor.
•
Measure the height (Y mm) of the disposer without legs including the 3mm rubber seal.
•
Lay down the disposer carefully on its side. Slide the three legs into respective clamp. Each leg
should protrude X-Y-2mm.
•
Tighten the clamps. Make sure that the legs are fixated, and that their position not have changed
during the tightening of the screw.
•
Place the disposer so that it stands on its legs. Move the disposer carefully into position under the
flange of the mounting assembly.
•
Using the six screws with nuts fixate the disposer onto the flange with the 3mm rubber seal in
between. Tighten the screws alternately and evenly until the rubber seal is compressed
approximately 1mm.
•
Use a jack or a leaver to push the disposer towards the flange of the mounting assembly.
•
While this upward pressure is maintained, untighten each leg and pull it downwards. Make sure
that all legs are firmly pressed against the floor. Tighten the clamps using a torque of 17Nm. As
this is a critical matter, a torque wrench should be used. If no torque wrench is available use a
leaver of approxematly 30cm and a force of 6kg.
