24(33)
User manual in Original
Dok. ref: User manual 500A-BS Rev. C
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: [email protected]
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
10.3.
Maintenance and Service of Assembly
For below designations within brackets, see exploded view of the disposer in section 10.2.
The following checks must be done in accordance to section 10.6. “Service and Maintenance
Intervalls”:
•
make sure the torque protection bar (-28/V) is fixed securely on the disposer and
wall/bulkhead.
•
make sure all screws and nuts (-22) are properly tightend and in good condition.
10.4.
Dismantling of Disposer
For below designation within brackets, see enclosed wiring diagram and exploded view of the disposer
in section 10.2.
1.
Use the main electrical safety switch to disconnect electrical supply and lock it with a padlock or a
cable tie.
2.
Disconnect the disposer cable from the star/stop unit.
3.
Disconnect the drain pipe from the end shield (-13) outlet connection.
4.
Put a trolley under the disposer. Disconnect the disposer from the mounting assembly (6 screws
and 6 nuts -22), and also from the torque protection bar (-28/V).
5.
Turn the disposer upside down to remove the housing (-15). Unscrew the 2 screws (-26). Loosen
the cable gland and push the cable inside the housing.
6.
Mark the position of the strap (-17) on the end shield (-13) and then remove it by loosening
the 2 nuts (-25)
. Turn the disposer back to an upright position.
