Dish Network Solo 301, Руководство пользователя

Страница: 47 / 106

Page 42
Chapter 3
Using the System
4. Select the
VCR Setup
option.
5. Find the brand name of the VCR in the table on page 66.
6. Set the code for the VCR using one of the following:
• Enter the first 3-digit code number from the table using the
NUMBER PAD
buttons.
• Highlight each digit of the first VCR code, and
then press the
UP
or
DOWN ARROW
button until
you reach the correct number and then press
SELECT
.
7. Make sure the VCR is turned ON and the switch is set
to 3 or 4 (whichever you use). Insert a rewound tape on
which you want to record. The receiver starts the VCR
recording, but does not turn ON the VCR, so you must
do this yourself.
8. To test the new code, highlight the
Test
option. The receiver displays a
message warning you to make sure the VCR is turned ON.
9. Press the SELECT button to start the test. Your VCR
records for a few seconds, stops, and then rewinds. The
receiver displays a message saying that your VCR test is
complete. Follow the instructions on the message.
10. If your VCR did not complete the test, enter another code
from the table, and then repeat steps 5 through 8.
11. Once you have found the correct VCR code select the
Save
option to
save the VCR code you entered and return to the Installation and
Setup
menu.
U
SING
L
OCKS
First you set the locks; then you lock the receiver. You must lock
the receiver in order to put any locks into effect. If you unlock
the receiver, leave the locks unchanged, and then lock the
receiver again, the same locks will be in effect as before.
H
OW TO
S
ET
L
OCKS
: A T
WO
S
TEP
P
ROCESS
1. Create the locks that you want.
2. Lock the receiver.
Once the receiver is locked, anyone who wants to access locked items
must enter the password.