Dish Network Solo 301, Руководство пользователя

Страница: 16 / 106

Page 11
Control Other Devices with the Remote
Page 11
S
ATELLITE
V
IDEO
R
ECOVERY
Follow these instructions if you accidentally change the channel or video
input on your TV and cannot get the picture back from your satellite TV
receiver. When you press the
RECOVER button as described below, the
remote control sends commands to your TV to change channels or video
inputs to try to get you back to watching satellite programming. This
procedures works only if you have accidentally changed the channel or
video input and does not recover lost satellite signal (See
Chapter 5 -
Reference for troubleshooting information). Satellite Video Recovery only
works if the remote control has been set up to control the TV and/or VCR.
Note : You may need to press the
RECOVER
button up to 30 times to
recover your satellite TV video.
1. Press and hold the RECOVER button until all four mode buttons light,
and then let go of the button. The
SAT
mode button flashes twice and
then all four mode buttons flash three times.
2. Press the RECOVER button. The TV mode button flashes once and
then all four mode buttons flash once.
Note : Recover will first try to tune your TV to channel 3, then channel
4, and then other video inputs.
3. If you see the
Important System Information
screen, press the
SELECT button to close the screen. You have recovered your satellite
video.
4. If you do not see the Important System Information screen, repeat
steps 2 and 3 until you have recovered your satellite video.
Note
: Press any remote control button other than the RECOVER but-
ton to end this procedure.
C
ONTROL
O
THER
D
EVICES WITH THE
R
EMOTE
R
EMOTE
C
ONTROL
M
ODES
You can set the remote to four different modes to control the receiver or
other devices. This section explains how to set up the remote to control a
device, such as a satellite TV receiver, a TV, a VCR, a DVD player,
a tuner, or an amplifier.
To set the remote to the right mode for a device, use the remote control’s
mode buttons,
SAT (satellite receiver), TV , VCR (for a VCR or a DVD
player), and
AUX
(“auxiliary,” for a DVD player, or an audio amplifier). To
change the mode, press the button for the device you want the remote to
control. The mode button flashes once to show you’ve set the remote to that
mode.
Tip: You
program the
remote that
came with your
receiver to
control as many
as three other
devices.