Dish Network LCD30-500, Руководство пользователя

Страница: 35 / 49

Page 31
Removing the Speakers
Removing the Speakers
The DISH Network LCD monitor is shipped with its speakers attached. If
you want to detach the speakers, follow these instructions.
Note
: Make sure the monitor’s power is disconnected before attaching or
detaching speaker connections.
1. Turn off the monitor, and unplug it from power.
2. Detach both speaker cables from both the speaker and the monitor.
3. On each speaker, there are two plastic covers. Squeeze them on the top
and bottom and carefully pull them off.
4. Behind each cover are four Phillips-head screws. Unscrew them.
Note:
As you unscrew the speakers, make sure to hold the speaker to
prevent it from being damaged in a fall.
5. Store the screws, covers, and speakers.
Restoring Your Remote Control’s Factory Settings
for Monitor Control
Your remote control provided with your DISH DVI-equipped DISH
Network satellite receiver comes from the factory ready to work with your
DISH Network HDTV monitor. However, the TV mode button can be
programmed to operate other TVs (refer to your DISH Network satellite
receiver User’s Guide for more details). If the remote control has been
programmed to operate a different TV, you can restore the remote control
factory settings to control your DISH Network HDTV monitor by
performing the following:
1. Press and hold the
TV button until all four mode buttons light.
Release the button.
2. Use the NUMBER PAD buttons to enter 7 - 4 - 2 .
3. Press the POUND ( # ) button. If you entered the
code correctly, the TV mode button will flash three times.
4. Press the SAT button and the monitor should turn on. If it doesn’t
turn on, repeat steps 1 through 4.