Dish Network LCD30-500, Руководство пользователя

Страница: 34 / 49

Chapter 4
Page 30
Installation and Setup
Connect the Speaker Cables
Connect the speaker cables from the
monitor
to the speakers. Make sure
that the black cylinders on the cables are closer to the
monitor
connection
than the speaker connection as shown on page 28. Make sure each speaker
wire is connected to the same color on both ends - red to red, black to black.
Note:
If speaker wire clips are included on the back of the monitor, you may
place the speaker wires through the clips for a cleaner looking installation.
Plug In Your Monitor to a Power Outlet
Connect the power supply’s DC power cable to the monitor by plugging the
special round connector to the Media Box’s
P
OWER
I
N
connector on the back.
The notch on the round connector when properly positioned will face you.
Plug the other provided power cable into the power supply, and connect the
power supply plug to a power strip.
Installing the Media Box Stand
The DISH Network LCD monitor is shipped with a stand to hold the Media
Box upright. Complete the following instructions to mount the Media Box
on the stand.
1. Turn off and unplug the monitor.
2. Disconnect all of the cables from the Media Box.
3. Remove the Media Box by pressing down and holding the locking clip
at the bottom of the Media Box while gently pulling the Media Box up
and then away from the monitor.
4. Turn the Media Box so that the DISH Network logo is right side up.
5. Place the stand on the right side of the Media Box.
6. Align the holes on the stand with the holes on the Media Box.
7. Insert and tighten the two screws included with the monitor.
8. Reconnect all of the cables as described in Connecting Your HDTV
Monitor starting on page 28.
F
G