Dish Network Duo ViP 222, Руководство пользователя

Страница: 98 / 143

Chapter 11
90
Connecting to the Remote TVs (TV1 or TV2)
Connecting Other TV(s) (TV1 or TV2)
If you’re using TV1 in a room away from the receiver, be sure to order the replacement remote
control that uses UHF Pro signals instead of IR. Call your DISH retailer for assistance, or visit the
www.mydish.com website, select Upgrades, and then Remotes & Accessories.
When connecting to the H
OME
D
ISTRIBUTION
coaxial jack, you must meet the FCC requirements in
the Appendix. To meet these requirements, your receiver includes a software-based attenuator:
• If connecting to your in-home cabling system to distribute the signal to a TV(s) in other rooms,
in most cases you will not have to enable the attenuator on the H
OME
D
ISTRIBUTION
output jack
for typical in-home cabling systems.
• If connecting directly to a nearby TV tuner input jack, you must enable the attenuator between
the receiver’s H
OME
D
ISTRIBUTION
jack and the TV tuner.
1
Connect the tuner input of the remote TV(s) in other rooms to an existing wall cable outlet using a
coaxial cable.
2
Turn on every remote TV connected to the in-home cabling system.
3
Find three channels next to each other on one of your remote TV(s) that do not pick up any signals
from over-the-air or cable broadcasts (they should show nothing but snow or static). These
channels must fall in one of the two ranges below. For example, if you find that cable channels 75,
76, and 77 do not pick up any broadcasts, pick these channels since they fall into the range below
for cable channels. Make sure these three channels on other remote TV(s) also do not pick up
broadcasts.
• Air Mode—Select a channel between 21 and 69 if your TV(s) will be set in Air Mode.
• Cable Mode—Select a channel between 73 and 125 if your TV(s) will be set in Cable Mode.
Note: The remote TV(s) will have to be set to the same channel mode, either air or cable channel
mode for this installation. See your TV user’s guide for instructions on how to set your TV to air or
cable channel modes.
4
Pick the channel in the middle of the three you selected in step . Write that channel down in the
blank provided in step 5. For example, if the three channels you picked in the preceding step were
air channels 60, 61, and 62, pick channel 61 and write it in the space provided in step 5.
5
If your TV is set to over-the-air mode for the channels you picked in step 4, circle “Air” below. If
your TV is set to cable mode for the channels you picked in step 4, circle “Cable” below. If you are
If you have an over-the-air antenna or cable connected to your in-
home cable system, see
Connecting an Over-the-Air Antenna
in the
next section.
Make sure you are familiar with how to change channels on your TV
and if necessary how to switch your TV between over-the-air (OTA)
and cable channels. During this procedure, it will be necessary to
change the channels on your TV(s) to tune to these channels to see
the video from the receiver. See your TV user’s guide for instructions.