11
5. Press the
RECORD
button.
6. Make sure the
System Information
screen shows the
address number you entered in step 3.
7. Close the
System Information
screen. On most
receivers, this is done by selecting
Done
. See your receiver user's
guide for more information.
C
HECKING
THE
R
EMOTE
C
ONTROL
A
DDRESS
To check the remote control address setting:
1. Press and hold the
SAT
mode button for three seconds
until all mode buttons light. Then, let go.
2. Press the
POUND
(
#
) button twice while watching the
SAT
mode button.
3. Count the number of times the
SAT
mode button flashes.
This number is the remote address. For example, if the
SAT
mode button flashes 6 times, this indicates the
remote address is set to 6.
S
ETTING
U
P
TO
C
ONTROL
O
THER
D
EVICES
To use the remote to control other devices (such as a TV, VCR, DVD
player, tuner/amplifier, or a second DISH Network satellite receiver),
you must first program it to control these other devices. You can do this
by either following the instructions in
Setting Up Using Device Code
Tables
on page 12, or the
Setting Up Using Device Codes Scan
procedure described on page 13.
C
OMBINATION
D
EVICES
If you are programming the remote to control a combination device,
such as a TV/VCR or a TV/DVD, program the remote control in one
mode, and then repeat the procedure in the other mode. For example, to
program the remote to control a TV/VCR using code 748, follow the
instructions to program the remote to control the TV using code 748,
and then repeat the instructions for the VCR using the same code.
L
IMITED
M
ODE
You can program your remote control in Limited Mode to keep from
accidentally changing the channel on your TV or VCR. When you use
the remote to control your TV in Limited Mode, you will only be able
to use the
POWER
,
MUTE
, and
VOLUME
buttons to control your TV.
Pyramid.book Page 11 Wednesday, February 16, 2005 4:00 PM
