PAGE 16 — MRH601DS VIBRATORY ROLLER • OPERATION MANUAL — REV. #1 (06/10/20)
COMPONENTS
Figure 2 illustrates the location of the major components
for the MRH601DS Vibration Roller. The function of each
component is described below:
1.
Traveling Lever
— Push the lever forward, the roller will
move in a forward direction, pull the lever backwards,
the roller will move in a backwards direction. Placing
the lever in the middle (midway) will cause the roller
not to move (neutral).
2.
Handle Bar
— When operating the roller, this handle
is to be in the downward position. When the roller is to
be stored, move the handle bar to the upright position.
3.
Water Tank
— Holds 7.9 gallons (30 liters) of water for
the sprinkler system.
4.
Water Tank Cap
— Open to fill water tank.
5.
Lifting Hook
— Used to lift unit with crane or other
lifting device when transporting.
6.
Oil Tank
— Fill with proper grade of hydraulic oil.
7.
Horn
— Gives a warning sound of the machine
approaching, for jobsite safety.
8.
Front Headlights
— Activate using switch on control
handle. Used to illuminate ground during nighttime or
low-light operating conditions.
9.
Scraper (In)
— Prevents buildup of material between
the drums.
10.
Scraper (Out)
— Prevents buildup of material between
the drum and the frame.
11.
Engine Starting Switch
—
ON
position permits engine
starting,
OFF
position stops engine operation.
12.
Vibration ON/OFF Switch
— Turns vibration on and
off.
13.
Handlebar Stopper Pin
— Locks handlebar in place.
14.
Fuel Tank/Cap
— Fill with diesel fuel. Fuel tank holds
approximately 2 gallons (7.5 liters).
DO NOT
top off
fuel. Wipe up any spilled fuel immediately.
15.
Coolant Radiator Cap
— Open to fill radiator with
coolant.
16.
Breather Cap
— Allow pressure to escape to the air
in the form of a gas from heat.
17.
Hydraulic Oil Filler Port
— Used to fill hydraulic oil
tank.
18.
Battery
— Pr12VDC to the electrical system.
Replace only with recommended type battery.
19.
Dead-Man Device
— When pressed or hit while
traveling in reverse, causes the travel lever to return
to neutral position to stop the machine.
20.
Muffler
— Used to reduce noise and emissions.
21.
Air Cleaner
— Prevents dirt and other debris from
entering the fuel system.
22.
Engine Oil Filler Port
— Used to fill engine oil.
23.
Fuel Cock
— Controls the flow of diesel fuel to the
engine. Must be in the
ON
position when starting and
running the engine.
24.
Throttle Lever
— Placed in operation position at start
up.
25.
Stopper
— Holds handlebar.
26.
Drain Outlet
— Drains out the water from the water
tank.
27.
Headlight ON/OFF Switch
— Turns the headlight on
and off.
28.
Horn Button
— Press this button to sound horn.
29.
Hour/Tacho Meter
— Measures the run time of the
unit. During operation it displays the rpm reading.
30.
Parking Brake
— Makes sure machine will not
accidentally move when parked or not in use. Move
lever to the left to place parking brake in the locked
position.
31.
Sprinkler Cock
— Turns on the sprinklers (front and
rear drums).
To
order
go
to
Discount-Equipment.com
