MRH601DS VIBRATORY ROLLER • OPERATION MANUAL — REV. #1 (06/10/20) — PAGE 21
OPERATION
12. If the buzzer does not stop sounding after the engine
has started, shut down engine immediately and check
engine oil level. The buzzer also functions as engine
oil level warning.
TRAVELING
1. Before starting to travel, make sure to release parking
brake (Figure 14).
Figure 14. Parking Brake
2. Push the travel lever forward slightly. This will cause
the roller to travel forward at slow speed.
Figure 15. Travel Lever
3. To increase the travel speed, push the travel lever
further.
4. Push the travel lever backward to go in the reverse
direction.
PARKING BRAKE
REAR WHEEL DRUM
LOCK
RELEASE
TRAVEL LEVER
STOP(NEUTRAL)
REVERSE
FORWARD
CAUTION
Do not reduce speed during work. When shifting travel
lever from forward to reverse, be sure to stop the lever at
the neutral position first before moving the lever to the
opposite direction. Do not shift the lever from forward to
reverse (or reverse to forward) in one motion.
VIBRATING
1. Shift the vibration switch from off to on position. The
roller will start vibrating (Figure 16).
Figure 16. Vibration Switch
2. If vibration does not occur (electromagnetic clutch does
not operate) while other functions are working properly,
the fuse might be blown. Check the fuse (10A) in the
handle box (Figure 17) and if it is blown, replace with
a new one.
Figure 17. Location of Fuse (Handle Box)
CAUTION
After test travel, shut down engine and check for any
problems including oil leakage. If any trouble is found,
correct the problem before attempting to operate the
roller again.
ON
VIBRATION SWITCH
(ON-OFF)
HANDLE BOX
CAUTION
Vibration should not be used over completely
compacted area, paved road surface, or with stationary
roller.
To
order
go
to
Discount-Equipment.com