Elite MicroPrint
Setup Guide
8
This brief setup guide is provided to get the Elite MicroPrint operational out of the box. Once
you get the system operational, complete help can be accessed from the Discus HELP
Section.
Step 1
Unpacking the Hardware
:
Your Elite MicroPrint system is shipped in one main carton. The printer is contained in a
second carton.
Carefully open the main carton and remove the top protective cardboard sheet. You will then
be able to remove the following:
Main Carton
DB9 Serial Loader to PC Cable
AC Power Cord
Printer Guide Plates (2 pcs)
Printer Control Cable
Printer Parallel Cable
Installation CD for Label Printing Software
Installation CD for Elite MicroPrint Software
Hardware Setup Manual
Set the components on a table that will hold the Elite MicroPrint unit and your PC. Next, by
lifting straight up, carefully remove the foam container and foam protection over the Elite
MicroPrint unit. You will see the Elite MicroPrint in a plastic bag.
Grasp the Elite MicroPrint on the top section and place the other hand underneath the unit.
Gently lift out of the shipping box and set onto a table.
Remove the Elite MicroPrint out of the bag and place all shipping components back into the
shipping carton for future use. It is important to always ship the Elite MicroPrint in its proper
container so storage of the box and accessories is important. In the event you misplace your
packaging and need to ship the Elite MicroPrint, contact the service department and a new
shipping container will be shipped out.
Next remove the printer from its shipping carton and place all the components on the table.
Account for all the components.
