Elite MicroPrint
Setup Guide
12
Step 3
Installation and Connection of AC Power, Serial and Printer Cables
Plug the Serial Cables, Printer control, Parallel Print Cable and AC power cord into each of
their identified connections located on the rear of the Elite MicroPrint unit. These connections
are identical to the common connections of standard computers.
Arrange your PC hardware on the same table as the Elite MicroPrint unit. Connect the other
ends of the Cables to their respective connections on your PC.
Plug the power cord into the power supply of the Elite MicroPrint, also located on the rear
side. Plug into a standard 115VAC outlet.
It is recommended to plug these components into a common plug strip with AC filtering, as is
common with most high-end computers. Also if the unit is to be located in an area where the
utility or power company experiences frequent outages, utilizing a UPS is strongly
recommended.
Connection of AC Power, Serial and Printer Control
(This figure is shown with the optional write drive upgrade)
NOTE: Review your entire unit and be sure that you have four cables connected to
the Elite MicroPrint Unit, three (3) cables connected to the printer and (2) cables
connected to your PC.
