of
11
12
Setup Menu
We’ve covered some of the more common setup tasks throughout this manual, but here is the full Setup reference in case you want to
dive in deep and really get to the nuts and bolts of your DMC.micro.
To enter Setup, hold the LEFT button on the DMC.micro when “DISASTER AREA” scrolls on the display. Release the button
when you see “SETUP” scroll.
Tap the left or right buttons to navigate through the setup menu.
Hold the left button to enter or exit a sub-menu.
Hold the right button to save the setup and exit.
PRST:
Sets the number of presets available in Preset Mode. Ranges from 1-99. Set to OFF to disable Preset Mode.
P CH:
Sets the MIDI channels on which Preset Mode will send messages. A, B, or C in any combination.
DEV:
Sets the number of active Device Mode pages. A, A+B, or A+B+C. Set to OFF to disable all Device Modes.
DEVA:
Configures the device driver type for the A device. Please consult the table on page 5 of this manual for full details.
DEVB:
Configures the device driver type for the B device. Please consult the table on page 5 of this manual for full details.
DEVC:
Configures the device driver type for the C device. Please consult the table on page 5 of this manual for full details.
LPR:
Sets the device that the DMC will use for looper control. A, B, or C. Set to OFF to disable Looper Mode.
UTIL:
Enables or disables the Utility Mode.
Please consult page 10 for more details on Utility Mode settings!
U LT:
Utility Mode, left button message type.
U LN:
Utility Mode, left button message number.
U LL:
Utility Mode, left button message low value.
U LH:
Utility Mode, left button message high value.
U LC:
Utility mode, left button message channels.
U RT:
Utility Mode, right button message type.
U RN:
Utility Mode, right button message number.
U RL:
Utility Mode, right button message low value.
U RH:
Utility Mode, right button message high value.
U RC:
Utility mode, right button message channels.
U AT:
Utility Mode, alternate (left hold) button message type.
U AN:
Utility Mode, alternate (left hold) button message number.
U AL:
Utility Mode, alternate (left hold) button message low value.
U AH:
Utility Mode, alternate (left hold) button message high value.
U AC:
Utility mode, alternate (left hold) button message channels.
Please consult page 12 for more details on MultiJack settings!
JACK:
MultiJack configuration.
J UR:
MultiJack Utility CC number.
J CH:
MultiJack Channel assignment.
BRT:
Display Brightness. Controls both display and the status LEDs. Ranges from 0-9.
HOLD:
Button Hold Time. Sets how long the user must hold a button to trigger the hold or alt function. Lo, Mid, High.
USB:
USB port function setting. HOST = USB host function for controlling a USB MIDI device with gHOST Adaptor.
MIDI = USB MIDI function for interfacing to a computer or iPad.
InCh:
MIDI Input channel setting. The DMC.micro will respond to incoming MIDI on this channel. Ranges from 1 to 16.
Set to OFF to disable MIDI input and MIDI thru.
DUMP:
MIDI SysEx dump. Not used in this version of firmware.
FACT:
Factory Reset. Clears all user settings and resets to factory specifications. Tap right button until “ALL” is displayed, then hold
the left button to reset. To exit without resetting, tap right button until “BACK” is displayed, then hold the left button.
Disaster Area Designs
DMC.micro
Gen3
Содержание DMC.micro
Страница 1: ...DMC micro User Manual v1 00c...
