9
WARNING:
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
NOTE:
Unplug cleaner before changing filter.
NOTE:
For best performance, replace filter yearly.
DIRT CONTAINER & FILTER: REMOVAL & REPLACEMENT
F1
FILTER TYPE
For F1 filter replacement (Part # 3-JCO280-000), please call 1-800-321-1134 or
visit our website at www.dirtdevil.com to locate a dealer nearest you.
Press latch above dirt container
and remove dirt container from
cleaner.
Hold the dirt container and
grasp the top of filter. Twist
and pull the filter up and out.
3.
Remove dirt container lid.
2.
Return filter to dirt container.
Push filter into place to prevent
dirt leakage. Return dirt
container to cleaner (see
Page 7, Install Dirt
Container).
5.
Clean filter and empty dirt
container completely. See
“Regular Maintenance” note
below for instructions on
cleaning the filter.
4.
1.
*REGULAR MAINTENANCE:
Each time the dirt container is emptied, the filter should be cleaned. Tap the filter
firmly against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use,
this will not affect the filter’s performance.) Do not brush the filter. The cleaning instructions may vary depending
on the dirt conditions. In some cases, more or less cleaning of the filter may be required.
It is recommended that
the F1 filter Part # 3-JCO280-000 be replaced once per year. Please use reminder label located on filter
cap to record replacement date.
EMPTY AND CLEAN DIRT CONTAINER
Secure by aligning the three
(3) tabs in the base slots.
SLOTS
TABS
10
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING:
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE CHANGING BELT
OR BRUSHROLL.
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
5
BELT STYLE
For Belt Style 5 replacement, please call 1-800-321-1134 or visit our website at
www.dirtdevil.com to locate a dealer nearest you.
Lay cleaner flat and flip cleaner to expose
nozzle base. Base should lay flat and
face up. To remove nozzle guard, use
Phillips screwdriver to remove the three
(3) screws. Arrows show location of
screws.
Lift and remove brushroll.
Dispose of old belt.
1.
3.
Pull and lift nozzle guard off.
2.
TO REMOVE BELT
Slide belt onto motorshaft.
5.
Place new belt in area of
brushroll without bristles.
4.
TO REPLACE BELT OR BRUSHROLL
With new belt in
place, pull and
slide brushroll
into nozzle
making sure
that the
brushroll end
caps are in the
correct orientation
(6a inset).
Rotate brushroll manually to make sure belt is
properly aligned.
6.
6a.
MOTOR SHAFT
Reattach nozzle guard.
8.
7.
Replace all three (3) screws
to secure nozzle guard.
9.
