53
8 Troubleshooting
GB
The wet cleaning
panel discharges
too much liquid.
The water tank cap was not shut properly or at all.
Close the water tank lid carefully,
Z
Chapter 5.2, “Prepare appliance for
wet cleaning“
.
The water dispenser was not put back on correctly or at all.
Push the water dispenser firmly into its holder,
Z
Chapter 7.3, “Replac-
ing the water dispenser“
. Then continuously check that it is securely fit-
ted.
You put too much liquid onto the wet cleaning cloth before attaching it.
Ensure that you always only damp the wet cleaning cloth.
When washing no
liquid or very little
liquid is discharged.
The water tank of the wet cleaning panel is empty.
Fill the water tank of the wet cleaning panel as described,
Z
Chapter 5.2,
“Prepare appliance for wet cleaning“
.
The bottom of the wet cleaning panel has
a small ventilation hole. This ensures that
a vacuum does not begin to develop in the
water tank and allows the water to be dis-
charged to the wet cleaning cloth easily.
This ventilation hole could be blocked.
Check and if necessary clean the ventila-
tion hole on the bottom of the wet cleaning
panel using a needle or a bent paper clip.
You did not moisten the wet cleaning cloth before attaching it.
Ensure that you always damp the wet cleaning cloth.
Problem
Possible cause / solution
1
NOTE:
If you cannot solve the problem using this table, contact our customer service department
(
Z
Page 192, "International Service"
) and describe the problem to us. Our staff are specially
trained for such cases and can help you get to the bottom of the matter in a targeted manner, and
solve the problem.
In this way, any inconvenience of having to send your cleaning robot to us can be avoided, and
you can use it again quicker.
