Direction-
Plus™
PLPV621DPK_Install
Page | 9
example of PL150DP fitting orientation
24.
Route the 10mm fuel hose to the inlet of the factory fuel filter and cut the hose to length, approximately 25mm past the
end of the inlet barb
25.
Install the last 9.89mm female quick disconnect fitting in the end of the same fuel hose and secure with a hose clamp.
Connect this hose to the inlet of the factory fuel filter and secure with a supplied hose clamp.
26.
Using the supplied nylon cable ties carefully secure both fuel hoses, ensuring they are not kinked and cannot contact any
hot components.
27.
Remove any loose tools from the work area
28.
Turn the ignition key ON and allow the system to prime for approximately 30-60 seconds, repeat 4-6 times
29.
Start and run the vehicle checking for leaks
30.
Refer to supplementary instruction for water alarm connection
Connection from fuel tank
Connection to factory
fuel filter INLET
