Direction-
Plus™
PLPV621DPK_Install
Page | 2
Ranger PX Engine Bay
–
Overall View
2.
Begin by locating the factory bypass hose which runs from the
valve cover on the driver’s side of the engine to the
intake
pipe just after the concertina section. The hose is about 500mm in length and has a few bends in it. Once located, this
hose needs to be disconnected from the valve cover and the 90° fitting on the valve cover needs to be rotated to face
the rear of the vehicle.
Factory bypass hose location
3.
Locate the
M6 nut located behind the fuse box on the passenger’s side. It needs to be removed to allow fitment of the
bracket.
ProVent® and Pre-
Filter kit mounts in
this corner
Bypass hose is
under the engine
cover in this corner
Disconnect hose
from here
