7
1-800-634-7328 DirectSupply.com
Installation Of Head and Foot Panels
Refer to Bed Panel Installation Sheet for more
Tools required: #2Phillips screwdriver
Head Panel Installation:
1. Head panel has label on back.
2. Lay panel on soft surface front face down.
3. Head panel brackets are longer of two sizes (Figure 5).
4. Install head panel brackets with four screws provided.
Bracket offset should face up (Figure 6). Do not tighten
until after fitting mounting brackets into bed sockets.
5. Go to final assembly below.
Frame-Mounted Foot Panel Installation:
1. Foot panel does not have label on back. Foot panel
will have staff control electronics, if staff control was
ordered.
2. Lay panel on soft surface front face down.
3. Foot panel brackets are shorter of two sizes (Figure 5).
4. Install the foot panel brackets with four screws
provided. Bracket offset should face up (Figure 6) Do
not tighten until after fitting mounting brackets into bed
sockets.
5. Go to final assembly below.
Final Assembly Step for Head Panel and Frame-
Mounted Foot Panel:
1. Insert head and foot panel as shown with mounting
hardware facing head of the bed
(Figure 7).
2. Tighten all screws with panels in place.
3. Panels should slip in and out of their sockets easily and
securely.
IV Sockets
Direct Supply Panacea 1000-FLEX Bed Platform has four
IV sockets as standard equipment. There are two sockets
at head end of bed and two at foot end (Figure 8). The IV
sockets are used with most ½" IV poles.
Figure 5
Head Panel
Bracket-10.5"
Foot Panel
Bracket-6.9"
Offset facing up
Figure 6
Figure 7
Figure 8
IV Socket
