DINSEO DIX TIG GO 1906.M HF, Руководство по эксплуатации

Страница: 17 / 26

17
1B - STANDARD CONFIGURATION
TIG welding
When one of the 2 TIG welding processes available on the weld-
ing power source is activated, this allows you to select the follow-
ing welding parameters, based on which LED is flashing:
L11 PRE-GAS duration
L12 SLOPE UP duration
L13 BASE current duration T
b
WARNING: This can only be programmed when SLOW pulsa-
tion is activated.
L14 PEAK current duration T
p
WARNING: This can only be programmed when SLOW pulsa-
tion is activated.
L15 SLOPE DOWN duration
L16 POST-GAS duration
L17 INITIAL welding CURRENT
L10 PRINCIPAL welding CURRENT I
1
L18 SWITCH CURRENT I
2
WARNING: This can only be programmed when the SWITCH
welding mode is active.
L19 BASE CURRENT I
b
WARNING: This can only be programmed when at least one pul-
sation mode is activated.
L20 PEAK CURRENT I
p
WARNING: This can only be programmed when at least one pul-
sation mode is activated.
L21 FINAL welding CURRENT
L22 PULSATION FREQUENCY f
WARNING: NOT programmable when SLOW pulsation mode is
active.
2 - SPECIAL CONFIGURATION
(only for expert welders)
TIG welding
For this configuration, in addition to the parameters already
defined for the STANDARD configuration, you can also set the
following parameters:
L8 IGNITION CURRENT
WARNING: This can only be programmed when the TIG with HF
ignition welding process is used.
L17 INITIAL welding CURRENT
WARNING: Only programmable for the welding process: TIG with
HF ignition and 2 TIME welding mode active.
L21 FINAL welding CURRENT
WARNING: Only programmable for the welding process: TIG with
HF ignition and 2 TIME welding mode active.
WARNING: This special parameter is only to be activated by
qualified personnel, or those trained by technicians.
Displaying the software version
installed
The power source is fitted with a digital control with software on
board defined in the factory. This software is subject to continuous
evolution and improvement. The software is identified by a
specific number that can be viewed on the DISPLAY (D) as follows:
1) When the welding power source is off, push and hold the
“MEM” SAVE key down (T1).
2) Start the welding power source by turning the power supply
switch to position I .
3) For a few seconds the DISPLAY (D) shows the type of soft-
ware on board (e.g. d01) where:
•
d indicates the welding power source model.
•
01 indicates the VERSION of the software installed
PULSE
SYN
FAST
SLOW
T1
D
Electrode welding (MMA)
1) Start the welding power source by turning the power supply
switch to position I .
2) WELDING PROCESS SELECTION
Push the WELDING PROCESS SELECTION key (T5) to
select the ELECTRODE welding processes for welding
with “HOT START” or “ARC FORCE” devices that can be
programmed by the user.
3) Turn the ENCODER Knob (E) until the DISPLAY shows the
CURRENT VALUE at which you wish to weld, in relation to
the diameter of the electrode you are using.
PULSE
SYN
FAST
SLOW
E
T5
T7
D