2
Connection to the electrical supply
MMA electrode welding (Fig. B)
The pointing out of any difficulties and their elimination 6
Procedure for welding power source assembly and
disassembly 6
Introduction
Thank you for purchasing one of our products. Please read in-
structions on use in this manual
as well as the safety rules giv-
en in the attached booklet
and follow them carefully to get the
best performance from the plant and be sure that the parts have
the longest service life possible. In the interest of customers, you
are recommended to have maintenance and, where necessary,
repairs carried out by the workshops of our service organisation,
since they have suitable equipment and specially trained person-
nel available. All our machinery and systems are subject to con-
tinual development. We must therefore reserve the right to modify
their construction and properties.
Description
DIX GO
is the latest evolution in inverter technology generators
for welding. The most advanced materials and components have
been used to design and produce it such as:
•
VRD (Voltage Reduction Device), which makes it possible to use
the machine in environments where the risk of electric shock or
electrocution caused by arc welding is enormously increased by
the presence of water, humidity, or heat, and particularly where
the ambient temperature exceeds 32°C. This device can be ex-
cluded by means of settings on the electronic board that controls
the inverter (see the “Deactivating the VRD device” paragraph).
•
Main planar transformer with extremely low load loss.
•
Electronic auxiliary feeder.
•
Voltage doubler ensuring precision striking, constant arc and
very low electrical input from the main supply by the welding
power source.
•
Extremely high frequency power INVERTER with very latest type
of IGBT to reduce switching losses to a minimum.
•
The inverter resists ample current variations (MAX 290V) and
can be utilized with very long electric cables (MAX 100 m).
•
Selector with 3 weld procedures:
- Basic and “cellulosic” electrodes with “Hot Start” and “Arc
Force” devices.
- Stainless steel electrodes with special characteristics for a
soft arc.
- TIG welding with thermal controlled (TCS) “Lift” type striking
reducing tungsten inclusions to a minimum and allowing to
also strike on sharp edges.
•
The generator also conforms to all European Union standards
and directives in force.
Technical data
The general technical data of the system are summarized in ta-
ble 1.
Copyright © 2018 DINSE G.m.b.H., Hamburg.
These instructions or excerpts there of shall not be duplicated, transla-
ted or reproduced, nor shall they be stored, processed, transmitted or
distributed by any electronic means without the prior written permission
of DINSE G.m.b.H.
D I N S E G . m . b . H .
Tarpen 36 • D-22419 Hamburg
Tel. +49 (0)40 658 75-0
Fax +49 (0)40 658 75-200
[email protected] – www.dinse.eu
