Dinolift DINO 260XT, Руководство по эксплуатации, Страница: 23 / 101

DINO 260XT
23
OPERATING THE LIFT FROM THE CHASSIS PANEL
10. Turn the selector switch (1) to position 3
-
now you can operate the boom using the levers 7, 8, 9 and 33 on the chassis panel
-
test the operation of the emergency descent system as follows:
1. start by lifting the boom up about 1 - 2 metres (with lever 8) and continue by extending the
telescope 1 - 2 metres keeping the emergency stop button depressed. The motor (and the
movement) should now stop
2. start the emergency descent power unit (pushbutton 5), retract the telescope (lever 9 or
pushbutton 31) and lower the boom (lever 8)
3. pull up the emergency stop button
-
start the electric motor (pushbutton 2, green)
Note! If you have levelled the chassis of the lift ON A GRADIENT turn around the boom carefully
to make sure that the turning device does not bang against the support outriggers.
-
lift the platform from the tow-bar and turn it to the side to enable its lowering
-
extend the telescope as much as necessary to ensure safe entrance on the platform
DO NOT DAMAGE THE TOW-BAR JOCKEY WHEEL!
The boom movements are noticeably slower when the emergency descent system is used.
The speed of the boom movements cannot be adjusted continually with the control levers when the lift is
operated from the chassis control panel.
Lock the selector switch (1) in position 1 (support outriggers) and stop the electric motor (red pushbutton
29) before working under the boom
Make sure that neither people nor load are on the platform.