Dinolift DINO 260XT, Руководство по эксплуатации

Страница: 20 / 101

DINO 260XT
20
3. Connection of power supply to the lift
A. POWERED BY AC-SUPPLY
-
connect the mains cable to the power supply
-
for maximum out of the electric motor the voltage must 230 VAC (-10%/ +6%), the frequency must
be 50 Hz and rating of the fuse 16A (the length of the connecting cable has some effect)
B. POWERED BY COMBUSTION ENGINE (POWER PACK)
-
do not connect the mains cable (230 VAC)
-
check that there is enough fuel in the tank.
-
open the fuel cock and switch on the choke for start.
If the battery is empty start the aggregate by pulling the starter grip keeping the button at the
aggregate bed depressed.
Pull the starter grip lightly until you feel resistance, then pull briskly.
Do not allow the starter grip to snap back against the engine.
-
adjust the engine speed to halfway.
Leave the combustion engine running between operations because the battery only recharges while the
engine is running.
Close the fuel cock when stopping the combustion engine.
Note! The fuel cock must be closed when the lift is towed.
For additional information concerning the operation of the combustion engine generator, please refer to
separate operating and service manual.