Dinli DL702, Руководство по обслуживанию, Страница: 81 / 99

【
7-6
】
ELECTRICAL SYSTEM
Electrical Wiring
Wiring Inspection
● Visually inspect the wiring for signs of burning, fraying, etc.
If any wiring is poor, replace the damaged wiring.
● Pull each connector [A] apart and inspect it for corrosion, dirt,
and damage.
If the connector is corroded or dirty, clean it carefully. If it is
damaged, replace it.
● Check the wiring for continuity.
○
Use the wiring diagram to find the ends of the lead which is
suspected of being a problem.
○
Connect the hand tester between the ends of the leads.
○
Set the tester to the x 1 Ω range, and read the tester.
If the tester does not read 0 Ω the lead is defective. Replace the
lead or the wiring harness [B] if necessary.
Battery
Battery Removal
● Disconnect the battery negative (-) cable [Black] first and then the
positive (+) cable [red].
● Take out the battery.
Battery Installation
● Connect the positive cable first and then the negative cable.
Battery Charging
The battery is a maintenance-free design and construction. Use of
conventional lead-acid batteries is not recommended. No
electrolyte or refilling water is required. Because this battery is a
completely sealed type, abuse of the battery can cause an explosion.
Please adhere to the following points:
1. Follow the instructions shown on battery package for
preparation and filling with battery electrolyte.
2. Never interfere with the sealed state of the battery.
WARNING
Keep the battery away from sparks and open flames during
charging, since the battery gives off an explosive gas mixture of
hydrogen and oxygen. When using a battery charger, connect the
battery to the charger before turning on the charger. This
procedure prevents sparks at the battery terminals, which could
ignite any battery gases.