Dinli DL702, Руководство по обслуживанию

Страница: 72 / 99

【
6-24
】
ENGINE
MOVABLE DRIVE FACE AND DRIVEN FACE
Movable drive face disassembly
● Remove the spacer.
● Remove the movable drive face plate and rollers.
Roller and sliding surface
● Inspect each roller and their sliding surface for wear or damage. If
any damages are found, replace the rollers as a set.
Oil seal
● Inspect the lip of the oil seal for wear or damage. If any damages
are found, replace the oil seal with a new one.
● Remove the oil seal.
Movable and fixed drive face
● Inspect each drive faces for any abnormal conditions such as
stepped wear or discoloration caused by burning. If any damages
are found, replace the drive faces with new ones.
● Install the oil seal with the special tool.
Reassembly
● Reassemble the movable and fixed drive face in the reverse order of
disassembly.
● Apply a small amount of grease to the bore and oil seal lip.
● Position the eight rollers on the movable drive face.
● Mount on the dampers on the movable drive face plate.
● Position the movable drive face plate on the movable drive face.
● Install the spacer.
NOTE
The rollers must always be changed as a set.
CAUTION
Wipe off any excess grease thoroughly.
Take care not to apply grease to the contact surface of the drive
belt.
NOTE
When inserting the spacer, press down the movable drive face
plate so as not to cause the rollers to come out of position.