Dinli DL702, Руководство по обслуживанию

Страница: 74 / 99

【
6-26
】
ENGINE
Reassembly
● Install the new O-rings.
● Apply grease to the oil seal lips and movable driven face inside
grease groove.
● Apply grease to the O-rings and pin grooves.
● Install the rollers and pins.
● Install the spring seat by aligning the holes.
● Install the spring and the spring plate by aligning the spring ends
with the holes.
● Compress the spring with the special tool.
● Tighten the movable driven face ring nut temporarily.
● Remove the special tool from the movable driven face assembly.
● Tighten the movable driven face ring nut to the specified torque
with the special tool.
Torque – Movable driven face ring nut: 110 N-m
DRIVE BELT
Inspection
● Check that the drive belt is free from any greasy substance.
● Inspect the contact surface of the drive belt for cracks or damage
and measure the width of the drive belt using the vernier calipers.
● If any damages are found or the measurement exceeds the service
limit, replace the drive belt with a new one.
Drive belt width
Service Limit 33.3 mm
Oil Pump
● Rotate the oil pump by hand and check that it moves smoothly.
● If it does not move smoothly, replace the oil pump assembly.
CAUTION
To prevent damaging the oil seal lip from during installation,
slide the lip using a 0.1 mm steel sheet as a guide.
CAUTION
If grease or oil is present on the surface of the drive belt, degrease
the belt thoroughy.
CAUTION
Do not attempt to disassembly the oil pump assembly.
The oil pump is available only as an assembly.