Dinli DL-901, Руководство по обслуживанию

Страница: 79 / 136

【
6-22
】
ENGINE
●
Apply oil to O-ring and install Starter Motor in position.
Tightening Torque: 9 - 11 N-m
Fastener : M6 X 25L 2 pcs.
●
Fit two Pipe Knocks and set Cylinder Gasket.
Assemble and install Piston.
●
Set Piston Rings into Piston grooves;
- Expander Ring into Oil Ring groove
- Second Ring, facing the marking upwards
- Top Ring, facing the marking upwards
●
Make sure rings are smoothly moved and adjust the openings
(gaps) at 120-degrees intervals.
●
Fit new clip into the groove on one side and make sure of the
clip fitting properly in the groove.
●
Place Special Tool; Piston Support Plate.
●
Insert Piston, with the marking on the top surface faced to
magneto side, into cylinder.
●
Apply oil to small end hole of Connection Rod, Piston Pin
and hole. Then fit Piston Pin into Piston.
●
Fit new clip into the groove on another side and make sure
the clip fitting properly in the groove.
●
Apply oil around Piston and Rings, and cylinder bore.
Install Cylinder by holding Rings by Special Tool; Ring
Band.
Make sure of the smooth operation by turning Crankshaft,
with Cylinder pressed down by hand.