Dinli DL-901, Руководство по обслуживанию

Страница: 70 / 136

【
6-13
】
ENGINE
TIMING CHAIN
Chain Pitch
●
Check for ware, damage and roller fallout.
●
Place Chain on the flat table and pull with the 4.53 kg force
and then measure the length of 20 pitches.
Timing Chain Pitch (20 pitches)
Service Limit 13.7 mm
STARTER GEAR/ONE-WAY CLUTCH
Disassembly
●
Remove One-way Clutch from Flywheel Assy.
Fastener; M6 X 16L Bolt (socket head)*8pcs.
CLUTCH
Visual checking – Pressure disk
●
Check for ware and damage.
●
Check for movement of bearing.
●
If any fault would be found, replace with new one.
Visual checking – Plate and Disk
●
Check for ware and deformation on Plate.
●
Check for ware and damage on Disk.
●
If any damage or excessive ware would be found, replace
with new one as a set.
Visual checking – Release shaft and Push rod
●
Check for ware and damage.
Width of friction material
●
Measure the width of friction material with caliper gauge.
Width of friction material
Service Limit 2.8 mm
Note:
Clutch Disk A and B are available.
Clutch Disk B should be facing front side.