Digium 1G101F, Руководство администратора

Страница: 22 / 100

Chapter 2: Unit Installation
„
Ethernet Status - These LEDs correspond to the status of the Ethernet
connection. See Frequently Asked Questions on page 80 for more
information.
„
USB Recovery - This port can be used to perform a firmware recovery
and configuration reset. See Firmware Recovery and Configuration
Reset on page 78 for more information.
Warning! The USB Recovery port provides a limited amount of
current which is sufficient only to power a USB flash drive. Do not
connect any other type of device to this port. The USB flash drive
should be fully USB 2.0 compliant.
„
T1/E1 Port(s) - These ports are used for connecting T1 or E1 cables.
See RJ45 T1/E1 Port Connector on page 86 for more information.
„
T1/E1 Status - These LEDs correspond to the status of the T1/E1
ports. See Frequently Asked Questions on page 80 for more infor-
mation.
„
Reset Switch (G400/G800 only) - This recessed switch is used to
restart the Gateway Series appliance or reset its GUI password. See
Frequently Asked Questions on page 80 for more information.
Digium, Inc. Page 22