Digitronic
CamCon Terminal
Automationsanlagen GmbH
DC51/T
5.1.3. Menu "2 Programme selection"
In this menu you accomplish a program selection for several devices at the same time. The program
selection functions
only
, if the communication mode (
"Ser.Mode"
) is adjusted to "
Multiuser
" or to
"
CAMBUS
". Before you can continue, enter your user key with the access to the program selection
If you did not assign a user key, enter the keycode "
5693
"
and press the key
. Afterwards the menu in the
screen, represented down, appears.
Only the devices marked with "#" are selected. After the
input of the program number the program selection
begins. That mark of the devices is possible only in the
submenu "device group" (see chapters 5.1.6.1. submenu
"device group" on page 11).
The already black supported devices were successfully
selected. In the example left in the device 3 the program
1 was selected. Next program 1 in device 4 is selected.
After completion of the program selection a message
appears. If an error message appears, then program
selection was not possible and is again to be
implemented. Possible sources of error are wrong device
numbers or errors in the wiring of the serial interface
The program selection can be left at any time by operation of the
key.
5.1.4. Menu "3 Unit list"
Select this menu to see an outline of all units with their unit numbers of the RS485 BUS. After selecting
this menu point, the following menu appears on the display:
If a device is found on the RS485 BUS, it is marked with an "X" after its unit number. The terminals
own unit number is marked by "--". Left above the recognized communication mode ("Ser.mode") is
indicated.
In the example, the unit numbers 0, 1, and 61 were found on the RS485 BUS whose communication
mode has been set to "
Multiuser
".
Press the
key to return to the main menu.
Version: Jul. 04
Page: 9
2 rue René Laennec 51500 Taissy France
Fax: 03 26 85 19 08, Tel : 03 26 82 49 29
E-mail:[email protected]
Site web : www.hvssystem.com
